Texas Cornhole Boards | Avarisk | Home Design | Interior, Exterior, Decoration, Remodel for Home

Texas Cornhole Boards

Texas Cornhole Boards

January 18, 2016

If you have questions about how to build a cornhole boards, then we can answer that question by doing the work itself. It is a fairly simple DIY job and will make us have a lot of fun, especially when doing it with friends or family. Each board will turn into a box with a slightly sloping top with a hole in the middle. The hole is large enough so that the beanbag that falls in it can fit snugly. This fun game will certainly add fun. To answer the question how to build a cornhole boards, then we will need a series of equipment ranging from 1 sheet of plywood thickness of 1 1/2 inches, wood putty, 2 by 2 wood length of 15 meters, power drill, decking screws 1 and 1/2 inches, saws, jig saw, power sander, pencil, and a tape measure. The first step on how to build a cornhole boards is to cut the wood. For that, we will divide it into several stages. Mark design cornhole boards that can be found in several sources on a sheet of plywood to determine the pieces that we need to apply. Image design doubled the size of 4 feet by 2 feet to form a rectangle. Mark four angled sides with a size of 9 inches, 4 inches, and 4 feet long. After that, draw of two other rectangles with a length of 2 feet wide and 1 foot. Label each piece before cutting to the next mark. 2 feet by 4 feet - platform, angled pieces - sides, smaller rectangles - backs. Cut out all the pieces of plywood and detach to each cornhole board. Make sure each cornhole board has a complete section - platform, two sides, and back. Make 6 pieces 1 1/5 meters long and 4 pieces 6 inches long by using a two by two, cut using a circular saw. It will be used as braces when we connect each piece of plywood together. The next step is to answer the question how to build a cornhole boards is to assemble each piece. Start by putting parts of the platform, Stand one piece angled side pieces so that the 4 sides of the feet touching one of the four sides of the foot platform. Connect the platform by placing one of the braces (the longest) on the board inside seam and apply the screws from the outside of the side pieces. Stand on the platform and screw the brace on the outside of the platform, repeat until each side is installed properly. Attach the back of a 2 foot platform that has a higher section. Adds the stability of the box to turn it over and attach the brace (smaller) on the inside of the joint between the back and each side. Make sure the back should end up with a long brace that holds the platform as well as smaller attached on each side of the corner. Determine the location for the target hole on the upper side of the platform to find the center after taking measurements and making the sign of each side. Make a hole with a diameter of 6 inches from center point using a drill and then use a jigsaw to cut. Apply wood putty, apply sandpaper until smooth, and questions how to build a cornhole boards has been resolved.


DIY, Do, Boards, Cornhole, Project, Simple,